RadiantQ Forum

Product => jQuery Gantt Package => Topic started by: tobias.leissner on March 31, 2015, 02:22:28 PM

Title: Using a percentage value for the width is the reason for not displayed columns
Post by: tobias.leissner on March 31, 2015, 02:22:28 PM

My situation
I'm using the FlexyGantt 4.5.53 to display different states of our servers. Therefore I'm using the sample "ServerStatus" from our sample page.
http://demos.radiantq.com/jQueryGanttDemo/Samples/ServersStatus.htm
Whenever the server state changes, I get a new entry into my Gantt.

My solution
I changed the width settings of the columns to get more space. By request I can provide the whole sample for further inspection.

Issues
When setting the width of a column by using a fixed amount of pixels or a number, everything works fine. However, when using a percentage value for the width, the columns do not get displayed anymore.

Expected behaviour
I expected that I can use a percentage value for the width of the columns, too, instead of fixed pixel values only.

I'm looking forward for a quick solution.

Best Regards
Tobias

Title: Re: Using a percentage value for the width is the reason for not displayed columns
Post by: amarnath on April 01, 2015, 01:05:47 PM

Tobias,

First we acknowledge that there no support for setting Gantt Table columns width in percentage, but still if you have single column in the table, it is possible to make that column to fill the entire width of the table. So could you please tell us how many columns do you have in your Gantt Table?

Thanks,
Amar 

Title: Re: Using a percentage value for the width is the reason for not displayed columns
Post by: tobias.leissner on April 01, 2015, 01:34:03 PM

Hey Amar,

I have at the moment two columns in my Gantt, but maybe I implement a third one.

Best Regards
Tobias

Title: Re: Using a percentage value for the width is the reason for not displayed columns
Post by: amarnath on April 02, 2015, 02:25:45 PM

Tobias,

Unfortunately we don't have support for setting Gantt Table columns width in percentage, we will be supporting this in one of our future updates.

Thanks,
Amar.